503.29ft in
25.17ft in
21.76ft in
52.5ft in
28.68ft in
38:12 :1
Siemens
AC Torque Control System
64.5
Komatsu AC Drive
Alternator Flow- 266 m3/min 9,380 cfm Wheel Motor Flow- 419 m3/min 14,800 cfm
24 volt, 250 amp
24 volt
Two/24 volt
328
239
194.9yd3
280yd3
719996.7lb
Flat floor configuration
89999.4lb
06mm 0.24\" 690 Mpa 1,00,000 psi tensile strength steel
10 mm 0.39\" Outer, 12mm 0.47\" Center, 1379 mPa 200,000 psi tensile strength steel
10 mm 0.39\" 1379 Mpa 2,00,000 psi tensile strength steel
16 mm 0.63\" Outer, 19mm 0.75\" Center, 1379 mPa 200,000 psi tensile strength steel
23.5ft in
18
2238
SSDA18V170
1900rpm
4759.9cu in
Diesel
3500.1hp
3345.9hp
4-cycle
25904.4lb
24802.1lb
Oil-cooled, hydraulic-actuated, multiple disc brakes at each wheel.
Multiple disc, spring-applied, hydraulically-released, dry brakes on inboard end of each wheel motor rotor shaft. Rated to hold on ±15% grade at maximum gross vehicle weight.
Automatically applied prior to hydraulic system pressure dropping below level required to meet secondary stopping requirements.
Switch-activated
4620
2750psi
103729
1400.2gal
190gal
350.1gal
90.1gal
37gal
1270021.3lb
549998.2lb
49.5%
50.5%
33%
67%
53/80 R63
Two 3-stage dual-acting outbound cylinders and internal cushion valve, over-centre damping.
Hoist and brake cooling- 17237 kPa 2,500 psi Steering and brake-20685 kPa 3,000 psi
Power-up loaded: 24 sec; Power-down: 14 sec; Float-down empty:24 sec
105ft in
250gal
In-line replaceable elements
Single, full flow, 100 mesh
Dual, in-line, high pressure
Two pumps, single package, end of alternator