45.61ft in
26.25ft in
2.19ft in
42.33ft in
26.19ft in
29.79ft in
35.02:1
GTA -39
AC Torque Control System
GDY108-C Induction Traction Motors
61
340 m3/min 12,000 cfm
24 volt, 250 amp
24 volt
Two/24 volt
303 mm 11.92\"
239 mm 9.40\"
240.7yd3
327yd3
814407.4lb
Flat floor configuration
92001.2lb
06mm 0.24\" 690 Mpa 1,00,000 psi tensile strength steel
10 mm 0.39\" Outer, 12mm 0.47\" Center, 1379 mPa 200,000 psi tensile strength steel
10 mm 0.39\" 1379 Mpa 2,00,000 psi tensile strength steel
16 mm 0.63\" Outer, 19mm 0.75\" Center, 1379 mPa 200,000 psi tensile strength steel
23.5ft in
18
2238
SSDA18V170
1900rpm
4759.9cu in
Diesel
3500.1hp
3345.9hp
4-cycle
25904.4lb
24802.1lb
Oil-cooled, hydraulic-actuated, multiple disc brakes at each wheel.
Multiple disc, spring-applied, hydraulically-released, dry brakes on inboard end of each wheel motor rotor shaft. Rated to hold on ±15% grade at maximum gross vehicle weight.
Oil-cooled, multiple disc front & rearAutomatically applied prior to hydraulic system pressure dropping below level required to meet secondary stopping requirements.
Switch-activated
Continuous at 4476 kW 6,000 hp
2750psi
103729
1400.2gal
190gal
350.1gal
90.1gal
25.1gal
1378499.8lb
564092.4lb
48%
52%
33%
67%
59/80 R63
Two 2-stage dual-acting outbound cylinders and internal cushion valve, over-centre damping
Hoist and brake cooling- 17237 kPa 2,500 psi Steering and brake-20685 kPa 3,000 psi
Power-up loaded: 21 sec; Power-down: 16 sec; Float-down empty:17 sec
105ft in
250gal
In-line replaceable elements
Single, full flow, 100 mesh
Dual, in-line, high pressure
Two pumps, single package, end of alternator